News

Hello, the following is the method of electric shear repair in different situations, you can refer to it, I hope to help you.

(1) When the electromagnetic vibration type electric shear emits large vibration and noise, the ingot screw is loosened, and the fault is expected to be eliminated. In addition, it is necessary to check the tightness of the screw of the press blade, the screw is too loose, easy to produce vibration and noise, and the phenomenon of not cutting the hair. The screw is turned too tight and will not vibrate easily. If the screws are properly tightened, the electric clippers will return to normal.
When the motor type electric shear emits large vibration and noise, it is necessary to check whether the motor is reversed, check whether there is loosening between the hand and the rocker arm, and appropriate adjustment can reduce vibration and noise.

(2) If it is found that there are three white roads in the hair rolled by the electric clipper, it is necessary to make appropriate adjustments. For electromagnetic vibration electric shear, as long as the ingot-shaped screw tightened some. For motor type electric shear, the brush on the brush holder can be pressed more tightly. At the same time to see whether the screw pressure blade is too tight, too tight should be relaxed.

(3) The time of each use should not be too long, and pay attention to the amount of cutting when using can not be too large, so as not to burn the coil. When the temperature of the coil is too high, it should be stopped.

(4) The blade on the electric shear should be refueled frequently, otherwise for a long time, there will be heat and vibration between the upper and lower blades.

(5) Because the electric scissors are directly in contact with the human body, special attention should be paid to safety. For an electric clipper with a rated voltage of 220V, a three-wire power cable must be used and the ground cable must be connected.

Tool head troubleshooting:
The tool head does not turn or rotates abnormally
1. Remove the cutter head, clean all parts of the cutter head, and check whether the motor has hair entanglement, after cleaning, install the cutter head and try again.
2. Take off the cutter head, turn on the switch, check whether the motor rotates, if it does not turn, try again after connecting the charger, still does not turn, the motor or rechargeable battery failure.

Pin one's hair
1. Pinch the blade by hand, if you can pinch it gently, the power is insufficient, and then use it after charging;
2. If the charger is connected to use, you can still gently pinch the blade, then remove the cutter head, clean the cutter head and fuselage, if the fault is still, the motor or rechargeable battery failure.
3. If the blade cannot be pinched and the blade head is strong, it indicates that the blade sharpness is not enough. Please remove the blade head and drop 1-2 drops of lubricating oil on the blade head. If the hair is still clipped after refueling, please replace the new cutter head in time.